Angel Custom 130% Extended Nozzle Return Spring for Airsoft GBB Pistols (Type: Hi-Capa and 1911 Series / Set of 3)

"mah jams have been fixed 😎

"great little upgrade to your glock! worked in my G19.

"What can you say, its a spring.. works fine in the Glock pistols and even works good in the Hi-Capa's as well. The spring is about 2mm short on the Hi-Capa but just a little stretch and it works just fine..

"The springs seem fine, Installed it in my tm and have had no issues yet, the spring lenght and when it is compressed is identical to the TM original spring.

I will be back here if i experience any "crushing" of the spring from the nozzle as I have only fired a few shots with it so far.

"Good replacement springs for a good price. These are a tad bit stronger and longer than the stock spring, but not as much as I was hoping. However, when it's only about $5 for three replacement springs, you can't complain much.

"Purchased these as a replacement spring for my Elite Force Glock 18C and turns out these springs DO NOT fit that model of gun, unlike what the description states. These springs are compression type springs and the original spring is a pull type spring with 1 small loop on each end. Springs measure 38mm long x 2.5mm diameter.

"These springs are stronger than the stock ones and I was hoping much longer that the stock to help push back the nozzle. Length is not that much longer and I think they should be 2-3 longer to really help push that nozzle or maybe angel custom should make a 140% or 150% spring.

They're cheap so the cost effectiveness is great for testing things. Honestly the hicappa spring I put in my glock was better and its basically compatible with glocks.

"They get up chewed pretty quickly but that’s my only complaint

"They are great when you first install it after like 100 ish shots it decompresses and you need to install a new one, I didn't buy mines from evike but I bought them from project n1 thinking they were good. Just stick with cowcow np1 they are hella more reliable.